GE Fuji Electric MICRO-SAVER AF-300 Instructions Manual page 11

(1) Keypad Part Names and Functions
Function Key (data key)
the various Function Codes and data
values during
frequency, current, voltage, etc. If a
fault occurs the cause of the problem
will be displayed as a code.
PROGRAM (PRG) Key - Normal
mode or program setting mode select
key.
FUNCTION Kev (data kev)
During the normal mode, this key can
be used to change the display unit
operation is either stopped or
running.
During the program mode, this key
can be used to read and write the
Function Codes and the data.
(2) Controlling Method for Keypad Panel
1 ) K e y p a d P a n e l o p e r a t i o n
W h e n t h e p o w e r s u p p l y a c t i v a t e d , t h e k e y p a d p a n e l display
I S
o n t h e right.
I f t h e m key p r e s s e d , t h e D r i v e
I S
f a c t o r y s e t t i n g . U s e t h e e
WARNING
RUN and STOP
RUN Key - Key used for starting
operation. The LED (green) lights up
during operation
This key does not function when
terminal operation control
selected.
IS
STOP Kev (Reset Kev) -This key
used for stopping operation
IS
s t o p p e d , t h e
LED (red) lights up.
The key does not function when
terminal operation
is selected. When any of the
protection functions are activated,
used to reset the fault.
IS
s t a r t a n d a c c e l e r a t e u p t o 6 0 H z a c c o r d i n g t o t h e
t o siop o p e r a t i o n
keys
function
only in Keypad operation mode. (Function Code F-2 setting is 0)
2 - 2
-STOP key (RESET key)
UP / DOWN Kevs - These keys
o r d e c r e a s e t h e
frequency reference. When unit is
changethe Function Codeordata
values
Unit Dimlay - Unit Information
displayed by LED (red) LEDs
also light up to indicate that the
The LED (green) lights up when
keypad panel operation
IS
I'
IS