GE Fuji Electric MICRO-SAVER AF-300 Instructions Manual page 30

TABLE 5: Terminal Identification/Function (continued)
Terminal Terminal
Label Name
Control TE minal Board Cont'd
FMA Analog Frequency
Meter Connection
Points
FMP Frequency
Meter ConnectIon
Fault Relay Output
3 0 A
3 0 B Terminals
3oc
Xl -x3 Multi-step Input
Function Selection
Deceleration
Output Function
RUN
NC Unused Terminals
Function
Provides an output of 0 to +I OVdc (+l OVdc at max frequency )
for Connection of a voltmeter (with internal resistance of
1 OK ohms.) See Function Code 46 for monitoring selection. Meter
connects between terminal FMA & 11.
Pulse frequency output equal to Drive output frequency -1440 Hz at
max. frequency. Meter connects between FMP and CM. (Pulse voltage.
Peak 5Vdc, 50% duty.)
between 30B and 30C. When a fault
and contact made between 30A and 30C. (Contact rating resistive
IS
load: 250 Vat, 0.3 Amps.)
Seven lndivldual
Time closed. When not closed #I setting
(F-43=1) 8 additional frequencies can be selected by Xi, X2, X3 and RTl
Drive running (open collector output, 27Vdc, 20 ma or less)
Do not connect anything to this terminal
not energized and contact
IS
detected, the relay
IS
preset selections F-43 = 0
time #2
activated.
IS
4-9
made
IS
energized
IS
selected when RTI -CM is
IS