BeaconMedaes HTM Instruction Book page 51

Enabling CAN for LAN operation
After changing the CAN address, CAN has to be enabled to ensure communication with the
Main controller.
To enable CAN, scroll down to <P.2> and press enter. You'll either see "On" or "OFF".
If it's on "On" CAN is already enabled.
If not, press enter and afterwards up or down to change "OFF" to "On". Confirm by pressing
enter.
Putting the dryer in LAN operation
As a final step of being able to control the dryer through the main controller, it has to be set put in
LAN operation.
To change the dryers operation, scroll down to <P.1> and press enter. By default you will see the
text "Loc". Press enter again, and by pressing up or down, change this value to "Lan".
Confirm by pressing enter.
Starting and stopping a dryer in local operation
When a dryer is in LAN operation, it will be started and stopped by the main controller. However,
by putting it in local operation, you can manually start and stop the dryer.
To do this, scroll down to <P.1> and press enter and adjust the onscreen text to "Loc".
After putting the dryer in local operation, you can start it with the "I" button, and stop it with the "O"
one.
Resetting a dryer operating in EFL operation
When the pressure switch of the dryer has been tripped by a too low pressure reading, this will
force the dryer in "Emergency forced local" operation. This operation will open the inlet solenoid
of the dryer and will start to normal pressurisation/equalisation cycle, until this "alarm" operation
has been reset.
To reset a dryer operating in EFL, push the Escape (X) button.
A dryer operating in EFL can be observed by the following:
• Blinking LAN symbol
• Blinking EFL triggered symbol
Warning LED lit
•
4233 5000 13 49