BeaconMedaes HTM Instruction Book page 46

3.3 Service Functions
Activate Service
This function is to activate service mode on the stand-by dryer. When activated this dryer will not
be put operational by the controller, a service-icon will be visible on the controller of the dryer and
it will display a blue led on the controller.
If the active dryer needs to be serviced, go to the Details Dryer screen and switch the active dryer
first (see above). If the active dryer is in purge control, ECO will not switch to the other dryer.
If the service function is activated, it will not be possible to switch dryers (either manual or
automatic).
Commissioning
This function is for drying both dryers before putting it into operation.
When activated:
Dryer 1 and 2 will be both enabled and work like in normal operation (regeneration –
pressurisation cycle)
A message of service mode icon is shown on both dryers in the dryer overview page. This
function will automatically be disabled after 72h.
44 4233 5000 13