Initial Inspection; Quickstart - Campbell Wind Monitor Series Product Manual

Wire color and functions of sensors purchased through Campbell Scientific may not
l
correspond with the wire colors and functions given in the manufacturer's manual. To
ensure proper function, follow the wiring provided in Short Cut or in the Campbell
Scientific manual.
Wind monitors purchased directly from R.M. Young may not have the 1 MΩ resistor used to
l
short the readings in the dead band to ground.

3. Initial inspection

Upon receipt of the wind monitor, inspect the packaging and contents for damage. File
l
damage claims with the shipping company. Immediately check package contents against
the shipping documentation. Contact Campbell Scientific about any discrepancies.
The model number and cable length are printed on a label at the connection end of the
l
cable. Check this information against the shipping documents to ensure the expected
product and cable length are received.
The wind monitors ship with:
(1) 1/16 inch hex key wrench from manufacturer (used for bearing replacement)
(1) Bearing gap gauge (spacer) from manufacturer (used for bearing replacement)
(1) Calibration sheet
(1) Ferrite choke from manufacturer
(1) Unthreaded aluminum pipe, 1-inch IPS, 12-inch length

4. QuickStart

A video that describes data logger programming using Short Cut is available at:
www.campbellsci.com/videos/cr1000x-datalogger-getting-started-program-part-3
is an easy way to program your data logger to measure this sensor and assign data logger wiring
terminals. Short Cut is available as a download on www.campbellsci.com. It is included in
installations of LoggerNet, RTDAQ, PC400, or PC200W.
The following procedure also describes programming with Short Cut.
. Short Cut
Wind Monitor Series 2