Table of Contents
Advertisement
52/65
Maintenance and repair
Connection cable
9.2
Service repair, maintenance and spare parts
9.2.1
Service and support
Service Germany
Service worldwide
Preparing information
Bosch Rexroth AG R911387136_Edition 02
WARNING
●
Change damaged connection cables and decommission
the plant immediately.
●
Do not repair any connection lines provisionally.
●
Check in regular distances the connection cables on damage and re‐
place them if necessary.
●
Check optionally existing drag chains (Drag chains) on defects.
●
Check the protective conductor connection for proper condition and firm
seating at regular intervals. Replace it, if necessary.
Wearing parts are reliably and professionally repaired and replaced by the
Bosch Rexroth Service in shopfloor-oriented quality.
The service lives of motor components, such as seals and bearings, may
vary depending on the operating conditions, such as operation mode, speed,
vibration and shock load, and frequent reverse mode.
We recommend to change the bearing after 30,000 operating hours. Shorter
replacement intervals may be necessary; cf. checks during operation
8.3 "Operation" on page
50.
We recommend regular visual inspections on shaft sealing rings. Depending
on operating conditions, signs of wear may appear after 5,000 operating
hours. If necessary, replace the shaft sealing rings.
We recommend to have these repairs made by Bosch Rexroth
Service.
Our worldwide service network provides an optimized and efficient support.
Our experts offer you advice and assistance should you have any queries.
You can contact us 24/7.
Our technology-oriented Competence Center in Lohr, Germany, is responsi‐
ble for all your service-related queries for electric drive and controls.
Contact the Service Hotline and Service Helpdesk under:
Phone:
+49 9352 40 5060
Fax:
+49 9352 18 4941
E-mail:
service.svc@boschrexroth.de
Internet:
http://www.boschrexroth.com
Additional information on service, repair (e.g. delivery addresses) and training
can be found on our internet sites.
Outside Germany, please contact your local service office first. For hotline
numbers, refer to the sales office addresses on the internet.
To be able to help you more quickly and efficiently, please have the following
information ready:
●
Detailed description of malfunction and circumstances
MS2E Synchronous Servomotors acc. to ATEX Directive
Death by electrocution possible due to live
parts!
2014/34/EU
chapter
Advertisement
Table of Contents
