Table of Contents
Advertisement
MS2E Synchronous Servomotors acc. to ATEX Directive
2014/34/EU
4.2.15
Coating
4.2.16
Noise emission
Code I / Code II (EN 60034-7)
IM B5 / IM 3001
IM V1 / IM 3011
IM V3 / IM 3031
Avoid liquid at the drive shaft or the shaft sealing ring in case of vertical in‐
stallation according to IM V3. For further information regarding the protection
class, see
chapter 4.2.8 "Degree of protection " on page
1K-standard varnish, water-based, RAL 9005 black
WARNING
An additional varnish on motors for hazardous areas is not allowed in order
not to negatively influence the surface characteristics (like e.g. insulation re‐
sistance, electrostatic charging).
The typical sound pressure level Lp(A) is specified for the speed range 0 rpm
up to the rated speed, see
lation situation affects the noise emission.
Flange attachment on the drive side of the
flange
Flange attachment on the drive side of the
flange, drive side facing down
Flange attachment on the drive side of the
flange, drive side facing up
Danger of explosion due to improper change
of the surface characteristics.
chapter 4.2.1 "Basic data" on page
R911387136_Edition 02 Bosch Rexroth AG
23/65
About this product
13.
9. The instal‐
Advertisement
Table of Contents
