Table of Contents
Advertisement
IDE Primary Channel Slave
This parameter lets you configure the hard disk drive connected to the
slave port of IDE channel 1.
IDE Secondary Channel Master
This parameter lets you configure the hard disk drive connected to the
master port of IDE channel 2.
IDE Secondary Channel Slave
This parameter lets you configure the hard disk drive connected to the
slave port of IDE channel 2.
The following screen appears if you select any of the IDE Drive
parameters:
IDE Primary/Secondary
Type ...........................[ Auto ]
Cylinder .....................[ XXXX ]
Head .........................[ XXXX ]
Sector .......................[ XXXX ]
Size .........................[ XXXX ] MB
Hard Disk Size > 504MB .........[ Auto ]
*Hard Disk Block Mode ...........[ Auto ]
*Advanced PIO Mode ..............[ Auto ]
*Hard Disk 32-bit Access ........[Enabled ]
*DMA Transfer Mode ..............[Auto]
*CD-ROM Drive DMA Mode ..........[Disabled]
The above parameters marked with '*' will only
appear if you access the advanced configuration
level in the Main Menu. Please refer to the
Entering Setup section for more information.
3-12
Channel Master/Slave
Type
Altos 500 System Guide
Advertisement
Table of Contents
