Table of Contents
Advertisement
Memory Test
When set to
Enabled
, this parameter allows the system to perform a
RAM test during the POST routine.
When set to
Disabled
, the
system detects only the memory size and bypasses the test routine.
The default setting is
Enabled.
Configuration Table
This parameter allows you to enable or disable the appearance of the
configuration table after POST but before booting. The configuration
table gives a summary of the hardware devices and settings that BIOS
detected during POST.
Boot from LANDesk Service Agent
When set to
Enabled
, the system boots from a LANDesk Service
Agent network instead of your desktop system. The LANDesk Service
Agent is IEEE-standards-based code that intervenes in the boot
process. Please refer to your LANDesk Manual for more information.
When set to
Disabled
, the system boots from the drive specified in
the Boot Sequence parameter.
3-24
Altos 500 System Guide
Advertisement
Table of Contents
