Network PTZ Camera·Quick Start Guide
Align
Installation of waterproof jacket
Figure 2-70
Steps:
1. Feed the network cable through ① and ③ in order.
2. Fix ② on the network cable between ① and ③.
3. Place ⑤ onto the end of ⑥, and plug the RJ45 male connector
into RJ45 female connector.
4. Screw ③ to ⑥ clockwise
5. Push ② into ③.
6. Secure ① with the ③ in clockwise direction.
2.10 Installation of Water-proof Tape
Purpose:
If the camera is installed outdoor, you can use supplied water-proof
tape to protect cable connectors and unused cables after the camera
is secured on the installation surface.
49