DeWalt DCS365 Instructions Manual page 49

TROUBLE
Saw will not start 1. Battery not installed
2. Battery not charged
3. Brushes worn out
Saw makes 1. Dull blade
unsatisfactory cuts
2. Blade mounted backwards
3. Gum or pitch on blade
4. Incorrect blade for work being done
XPS™ worklight is 1. Battery not charged
flashing
Machine vibrates 1. Saw not mounted securely to stand or
excessively work bench
2. Stand or bench on uneven floor
3. Damaged saw blade
Does not make 1. Mitre scale not adjusted correctly
accurate mitre cuts
2. Blade is not square to fence
3. Blade is not perpendicular to table
4. Workpiece moving
5. Kerf plate worn or damaged
Material pinches blade 1. Cutting bowed material
Troubleshooting Guide
BE SURE TO FOLLOW SAFETY RULES AND INSTRUCTIONS
WHAT'S WRONG?
1. Install battery. Refer to Installing and Removing Battery Pack.
2. Charge battery. Refer to Charging Procedure.
3. Have brushes replaced by authorised service centre.
1. Replace blade. Refer to Changing or Installing a New Saw Blade.
2. Turn blade around. Refer to Changing or Installing a New Saw Blade.
3. Remove blade and clean with coarse steel wool and turpentine or household
4. Change the blade type. Refer to Saw Blades under Optional Accessories.
1. Charge battery. Refer to Charging Procedure.
1. Tighten all mounting hardware. Refer to Bench Mounting.
2. Reposition on flat level surface. Refer to Familiarization.
3. Replace blade. Refer to Changing or Installing a New Saw Blade.
1. Check and adjust. Refer to Mitre Scale Adjustment under Adjustments.
2. Check and adjust. Refer to Mitre Scale Adjustment under Adjustments.
3. Check and adjust fence. Refer to Bevel Square to Table Adjustment under
4. Clamp workpiece securely to fence or glue 120 grit sandpaper to fence with
5. Take to authorised service centre.
1. Refer to Bowed Material under Special Cuts.
WHAT TO DO
oven cleaner.
Adjustments.
rubber cement.
english
47