Download Print this page

DeWalt DCS365 Instructions Manual page 42

Cordless sliding compound mitre saw

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 37
english
• If battery contents come into contact with the skin, immediately
wash area with mild soap and water. If battery liquid gets into the
eye, rinse water over the open eye for 15 minutes or until irritation
ceases. If medical attention is needed, the battery electrolyte is
composed of a mixture of liquid organic carbonates and lithium salts.
• Contents of opened battery cells may cause respiratory
irritation. Provide fresh air. If symptoms persists, seek medical
attention.
WARNING: Burn hazard. Battery liquid may be flammable if
exposed to spark or flame.
Transportation
D
WALT batteries comply with all applicable shipping regulations
e
as prescribed by industry and legal standards which include UN
Recommendations on the Transport of Dangerous Goods; International Air
Transport Association (IATA) Dangerous Goods Regulations, International
Maritime Dangerous Goods (IMDG) Regulations, and the European
Agreement Concerning The International Carriage of Dangerous Goods by
Road (ADR). Lithium-ion cells and batteries have been tested to section
38.3 of the UN Recommendations on the Transport of Dangerous Goods
Manual of Tests and Criteria.
In most instances, shipping a D
WALT battery pack will be excepted from
e
being classified as a fully regulated Class 9 Hazardous Material. In general,
the two instances that require shipping Class 9 are:
1. Air shipping more than two D
WALT lithium-ion battery packs when the
e
package contains only battery packs (no tools), and
2. Any shipment containing a lithium-ion battery with an energy rating
greater than 100 watt hours (Wh). All lithium-ion batteries have the watt
hour rating marked on the pack.
Regardless of whether a shipment is considered excepted or fully regulated,
it is the shipper's responsibility to consult the latest regulations for
packaging, labeling/marking and documentation requirements.
Transporting batteries can possibly cause fire if the battery terminals
inadvertently come in contact with conductive materials. When transporting
batteries, make sure that the battery terminals are protected and well
insulated from materials that could contact them and cause a short circuit.
The information provided in this section of the manual is provided in
good faith and believed to be accurate at the time the document was
created. However, no warranty, expressed or implied, is given. It is the
buyer's responsibility to ensure that its activities comply with the applicable
regulations.
Battery Pack
BATTERY TYPE
The DCS365 operates on an 18 volt battery pack.
The DCB140, DCB141, DCB142, DCB143, DCB144, DCB145, DCB180,
DCB181, DCB182, DCB183, DCB183B, DCB184, DCB184B or DCB185
battery packs may be used. Refer to Technical Data for more information.
Storage Recommendations
1. The best storage place is one that is cool and dry away from direct
sunlight and excess heat or cold. For optimum battery performance
and life, store battery packs at room temperature when not in use.
2. For long storage, it is recommended to store a fully charged battery
pack in a cool, dry place out of the charger for optimal results.
NOTE: Battery packs should not be stored completely depleted of charge.
The battery pack will need to be recharged before use.
Labels on Charger and Battery Pack
In addition to the pictographs used in this manual, the labels on the charger
and the battery pack may show the following pictographs:
Read instruction manual before use.
See Technical Data for charging time.
Battery charging.
40
Battery charged.
Battery defective.
Hot/cold pack delay.
Do not probe with conductive objects.
Do not charge damaged battery packs.
Do not expose to water.
Have defective cords replaced immediately.
Charge only between 4 ˚C and 40 ˚C.
Only for indoor use.
Discard the battery pack with due care for the environment.
Charge D
WALT battery packs only with designated D
e
chargers. Charging battery packs other than the designated
D
WALT batteries with a D
e
or lead to other dangerous situations.
Do not incinerate the battery pack.
Package Contents
The package contains:
1 Mitre saw
1 Blade wrench
1 Saw blade
1 Side handle package
1 Dustbag
1 Material clamp
1 Instruction manual
NOTE: Battery packs, chargers and kitboxes are not included with
N-models.
• Check for damage to the tool, parts or accessories which may have
occurred during transport.
• Take the time to thoroughly read and understand this manual prior to
operation.
Description (Fig. 1)
WARNING: Never modify the power tool or any part of it.
Damage or personal injury could result.
A. Trigger switch
B. Operating handle
C. Mounting holes
D. Lower guard
E. Mitre lock knob
F. Kerf plate
G. Mitre arm
H. Mitre scale
I. Mitre scale screws
J. Side handles
K. Fence
L. Bevel lock knob
M. Rails
N. Dust port
O. Lifting handle
P. Battery pack
WALT
e
WALT charger may make them burst
e

Advertisement

loading