Sony PMW-PZ1 Service Manual page 49

3. Remove the front panel.
(1) Remove the two screws.
(2) Insert a thin plate into portion A on both sides and remove the bosses, and remove the two bosses of the upper
side of the unit, then remove the front panel assembly.
Note
Do not excessively spread the two portions A. If they are spread too wide, they may be deformed and cannot
return to their original form. The boss height is 0.5 mm.
Front panel assembly
Boss
Hole
Portion A
Thin plate
Note
When installing the front panel assembly, do not pinch the fine-wire coaxial cables and the harness.
4. Install the removed parts by reversing the steps of removal.
PMW-PZ1
B3 x 4
Holes
Holes
Boss
Boss
Fine-wire coaxial cables,
Harness
Boss
Boss
5-5