+
Damaged or worn components may impair your safety and the lifespan of the
equipment. You should therefore immediately replace damaged or worn components.
Please contact your contract partner in such a case. The equipment should no longer be
used until it has been repaired. When needed, only use original Taurus spare parts.
+
Check the tightness of all screw connections once a month.
+
In order to be able to guarantee the constructively defined safety level of this equipment,
we recommend having the equipment regularly maintained (at least once a year) by
specialists (service technicians of your contract partner).
+
The equipment may be cleaned of dust, dirt and sweat using a damp cloth. The use of
solvents should be strictly avoided. Also, make sure that no liquids (e. g. sweat) get into
the openings of the equipment (e. g. console).
2.2
Faults and troubleshooting
The equipment runs through regular quality controls during production. Nevertheless,
errors or malfunctions on the equipment may occur. Individual parts are often the cause
of faults and replacement is usually sufficient. Please use the following overview to see
the five most common errors and how to repair them. If the equipment still does not work
properly, please contact your contract partner.
Problem
Crackling noise in
pedal area
Equipment wobbles Equipment is not level
Handlebar/saddle
wobbles
Display does not
turn on
No pulse reading
10
Cause
Loose pedals
Screws are loose
Power is disconnected
• Sources of interference
in the room
• Using a chest strap:
- Unsuitable chest strap
- Chest strap is
incorrectly positioned
- Batteries are empty
Solution
Tighten the pedals
Adjust the supporting feet
Tighten screws
Check all plug connections and see if
the plug is plugged in
• Eliminate sources of interference (e. g.
mobile phone, loudspeaker, etc.)
• Use a suitable chest strap (see
recommended accessories)
• Reposition the chest strap and/or
moisten the electrodes
• Charge the batteries
RB10.5 Smart
Need help?
Do you have a question about the RB10.5 Smart and is the answer not in the manual?