Life Fitness Axiom OP-MP Assembly Instructions Manual page 27

4. Press gas shock onto the ball studs.
NOTE: Make sure gas shock is oriented as shown.
Cable Routing
1. Route cable out through hole at the bottom of tower side tube. Route cable through the lower pulley assembly.
2. Slide the carriage bolt to the end of the slot in the lower pulley assembly using a 17mm wrench.
3. Install screws and washers securing the lower pulley assembly to the tower frame using an 8mm Allen wrench.
Item
1
2
Item
1 Carriage Bolt, M10 x 1.5, 50mm
Tighten hardware to 20-25 ft-lb (27.1-33.9 Nm).
Item
1
2
3
4
5
Tighten hardware to 20-25 ft-lb (27.1-33.9 Nm).
Page 25 of 35
Description
Gas Shock
Ball Stud
Description
Description
Lower Pulley Assembly
Cable
Tower Frame
Washer, Flat 3/8"
Screw, M10 x 1.5, 25mm
Qty.
1
2
Qty.
1
Qty.
1
1
1
4
4