Life Fitness Axiom OP-MP Assembly Instructions Manual page 29

6. Install screw, washers, and locknut securing the bushings and rod end bearing to the work arm linkage assembly
using an 8mm Allen wrench and 17mm wrench.
Install Pads
1. Install screws and washers securing the seat pad to the seat assembly using an 8mm Allen wrench.
2. Install screws and washers securing the back pad to the seat back assembly using an 8mm Allen wrench.
3. Install hole plugs to the seat back assembly using a rubber mallet.
Test Unit For Proper Operation.
Item
1
2
3 Work Arm Linkage Assembly
4
5 Nut, M10 x 1.5, Hex Nylock
6
Tighten hardware to 8-10 ft-lb (10.8-13.5 Nm).
Item
1
2
3
4
Tighten hardware to 40-50 in-lb (4.5-5.6 Nm).
Item
1
2
3
4
5
Tighten hardware to 40-50 in-lb (4.5-5.6 Nm).
Page 27 of 35
Description
Rod End Bearing
Bushing, .235"
Washer, Flat 3/8"
Screw, M10 x 1.5, 55mm
Description
Seat Pad
Seat Assembly
Washer, Flat 3/8"
Screw, M10 x 1.5, 25mm
Description
Back Pad
Seat Back Assembly
Washer, Flat 3/8"
Screw, M10 x 1.5, 30mm
Hole Plug, 1"
Qty.
1
2
1
2
1
1
Qty.
1
1
3
3
Qty.
1
1
3
3
3