Specifications - Wilson Electronics weBoost Drive Reach RV Installation Manual

Specifications
Model
FCC
Connectors
Antenna Impedence
Frequency
Power output for single cell
phone (Uplink) dBm
Power output for single cell
phone (Downlink) dBm
Noise Figure
Isolation
Power Requirements
Each Signal Booster is individually tested and factory set to ensure FCC compliance. The Signal Booster cannot be adjusted without factory reprogramming or disabling the
hardware. The Signal Booster will amplify, but not alter incoming and outgoing signals in order to increase coverage of authorized frequency bands only. If the Signal Booster
is not in use for five minutes, it will reduce gain until a signal is detected. If a detected signal is too high in a frequency band, or if the Signal Booster detects an oscillation, the
Signal Booster will automatically turn the power off on that band. For a detected oscillation the Signal Booster will automatically resume normal operation after a minimum of
1 minute. After 5 (five) such automatic restarts, any problematic bands are permanently shut off until the Signal Booster has been manually restarted by momentarily removing
power from the Signal Booster. Noise power, gain, and linearity are maintained by the Signal Booster's microprocessor.
This device complies with Part 15 of FCC rules. Operation is subject to two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation. Changes or modifications not expressly approved by weBoost could void the authority to
operate this equipment.
Drive Reach Cell Signal Booster
698-716 MHz, 728-756 MHz, 777-787 MHz, 824-894 MHz, 1850-1995 MHz, 1710-1755/2110-2155 MHz
700 MHz B12/17 700 MHz B13
28.3 29.1
5.2 5.2
460054
PWO460054
SMB-Jack
50 Ohms
800 MHz B5 1700 MHz B4
29.50 28.50
5.2 5.0
5 dB (nominal)
> 90 dB
5V, 4.5A
1900 MHz B2
28.30
5.1
15