Troubleshooting - Wilson Electronics weBoost Drive Reach RV Installation Manual

Troubleshooting

FIXING BLINKING OR RED LIGHT ISSUES
This section is only applicable if the booster is red or blinking red and you are not
experiencing the desired signal boost.
1 Unplug the Booster's power supply.
Relocate the inside and outside antenna further from each other. The objective is
to increase the separation distance between them, so that they will not create this
feedback condition discussed before.
3 Plug power supply back in.
4 Monitor the indicator light on your booster. If, after a few seconds of 'power
on', a solid or blinking red light appears, repeat steps 1 through 3. Increase the
separation distance until the condition is corrected and/or desired coverage area
is achieved. Note: Horizontal separation of the two antennas typically requires a
shorter separation distance than vertical separation.
If you are having any di culties while testing or installing your booster, contact our
weBoost Customer Support team for assistance (866.294.1660).
10