Optional Blower Installation - Continental Fireplaces Builder Series Installation Manual

11.0 optional blower installation

fi nishing
EN
WARNING
!
• Ensure the appliance is completely cool before starting installation.
• To avoid danger of suffocation, keep the packaging bag away from babies and children. Do not use in cribs,
beds, carriages, or play pens. This bag is not a toy. Knot before throwing away.
A. Remove the screen by lifting it up and off of the appliance.
B. Remove the door from the appliance by releasing the door latches.
C. It may be necessary to move the control module aside during blower installation. (Electronic Only)
D. Attach the two 1/4" connectors (black and white) from the wire harness to the thermal disc.
E. Attach the two 1/4" connectors (black and red) from the wire harness to the blower.
F. Install the clear bumpers supplied onto the bottom of the blower to avoid the blower rubbing against the fl oor of
the appliance.
G. Pivot the blower into the bottom of the appliance. Ensure the gasket remains in place between the blower and
outer shell while sliding the blower against the left side of outer shell into the blower mounting tab. Secure in
place using one screw, see Figures 1 and 2.
NOTE: WITH THE WIRE CLIP SUPPLIED, ENSURE ALL WIRES REMAIN CLEAR OF THE BLOWER.
FIGURE 1
f i r e - p a r t s . c o m
SCREW
LOCATION
H. Place the control module back into its original position. Ensure the transformer is plugged into the outlet of the
electrical box.
I.
Install the variable speed switch (VSS) mounting bracket into position then reinstall the two previously removed
screws, refer to Figure 3. To install the variable speed switch, the mounting bracket will fi rst need to be installed.
Remove the two screws securing the piezo ignitor switch bracket in place.
J. The VSS will need to be disassembled to secure to the VSS bracket for installation. Place the VSS through the
mounting bracket using the lock washer to secure it in place. Take the variable speed switch knob and install into
position. (Refer to Figure 3.)
FIGURE 3
VSS
BRACKET
K. Plug the connector from the variable speed switch to the matching connection on the wire harness.
L. Bend the thermal disc bracket 90 degrees and secure it to the fi rebox mounting tab using the two screws
supplied, refer to Figure 4. Ensure that the thermal disc is in contact with the fi rebox base and that the wire
harness is properly attached.
M. Plug the power cord from the blower into the electrical box.
note:
The blower is thermally activated, so when it is turned on, it will automatically start approximately 15 minutes
after lighting the appliance and will run for approximately 30 minutes after the appliance has been turned off.
54
W415-1850 / A / 03.06.19
BLOWER
MOUNTING TAB
LOCATION
PIEZO IGNITOR
BRACKET
FIGURE 2
BLOWER BLOWER
FIGURE 4
THERMAL DISC THERMAL DISC
MOUNTING TAB BRACKET
REAR VIEW REAR VIEW
BLOWER BLOWER
MOUNTING MOUNTING
TAB TAB
FIREBOX BASE