Log Placement - Continental Fireplaces Builder Series Installation Manual

fi nishing
EN
10.6

log placement

WARNING
!
• Failure to position the logs in accordance with these diagrams or failure to use only logs specifi cally approved
with this appliance may result in property damage or personal injury.
• Logs must be placed in their exact location in the appliance. Do not modify the proper log positions, since
appliance may not function properly and delayed ignition may occur.
• The logs are fragile and should be handled with care.
TM
PHAZER logs and glowing embers, exclusive to Continental, provide a unique and realistic glowing effect that is
different in every installation. Take the time to carefully position the glowing embers for a maximum glowing effect.
Log colours may vary. During the initial use of the appliance, the colours will become more uniform as colour
pigments burn in during the heat activated curing process.
f i r e - p a r t s . c o m
A. Place the rear log (W135-0643) (A) fi rmly onto the
2 studs at the rear of the support tray. Ensure the
log sits fl at and does not cover the pilot opening.
Place 2 pins in the holes located on the top rear
of the rear log (A).
C. Position the right front log (W135-0645) (C)
onto the 2 studs located on the right side of
the log support.
E. Place the right crossover log (W135-0589) (E)
onto the pin located in the right side of the rear
log (A), allowing it to rest in the notch of the
right log (C).
52
W415-1850 / A / 03.06.19
PINS
A
A
C
B
D
E
A
C
B
B
B. Place the left front log (W135-0644) (B) onto the 2
studs located on the left side of the log support.
D
B
D. Place the left crossover log (W135-0546) (D)
onto the pin located in the left side of the rear
log (A), allowing it to rest in the notch of the left
front log (B).
F. Install the glowing embers and charcoal
embers (see "glowing embers" and "charcoal
embers" sections).
G. Reinstall the door and safety barrier (see
"safety barrier & door removal/installation"
section).
A
A
C