',0 5GJV
&/($5
287387
567
287387 0($692/7'&"# ! Configure the multimeter for DC voltage
(17(5 5GJV
35,17 5GJV
(1'
38 Getting Started
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
When the configuration is complete, turn mainframe power ON and verify
that the "VOLTMETR" driver version A.06.00 is installed in the E1406
Command Module (see Exercise 1). If the appropriate "VOLTMETR" driver
is installed, run the following program.
This program scans channels 0 through 31 of the multiplexer and makes a
voltage measurement on each channel. The measured readings are entered
into the computer and displayed after the scan. You can then check the
measured readings with the values of the resistor(s) you installed on the
channels.
! Dimension array to store readings
! Clear the scanning voltmeter
! Reset the scanning voltmeter
! measurements and specify channel list
! to scan (channels 00 through 31)
! Enter measured readings
! Display measured readings
Chapter 1