Agilent Technologies E1476A User Manual page 21

Terminal Module Option
Accessory
Single- A crimp-and-insert contact is crimped
Conductor and onto one end of a wire.
Contact The other end is not terminated. Order
91510A.
Shielded- A crimp-and-insert contact is crimped
Twisted-Pair and onto each conductor at one end of a
Contacts shielded-twisted-pair cable. The other
end is not terminated. Order 91511A.
Jumper Wire and A crimp-and-insert contact is crimped
Contacts onto each end of a single conductor
jumper wire. This jumper is typically
used to tie two pins together in a single
crimp-and-insert connector. Order
91512A.
Crimp-and- These contacts may be crimped onto a
Insert Contacts conductor and then inserted into a
crimp-and-insert connector. The crimp
tool kit is required to crimp the contacts
onto a conductor and remove the
contact from the connector. Order
91515A.
Crimp-and- The hand crimp tool (part number 91518A) is used for crimping contacts onto a conductor.
Insert Tools The pin extractor tool (part number 91519A) is required for removing contacts from the
crimp-and-insert connector. These products are not included with Option A3E or with the
terminal option accessories listed earlier.
Extra The crimp-and-insert connector is normally supplied with Option A3E. Contact Agilent if
Crimp-and- additional connectors are needed. Order 91484B.
Insert
Connectors
20 Getting Started
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Terminal module Option A3E (see Figure 1-9) provides a crimp-and-insert
A3E terminal module that allows you to crimp connectors onto wires which are
then inserted directly into the multiplexer's mating connector. See the
pin-out diagram (Figure 1-2) to make the connections. Table 1-1 shows the
accessories that can be used with crimp-and-insert Option A3E.
Figure 1-9. Option A3E Crimp-and-Insert Connector
Table 1-1. Option A3E Terminal Module Accessories
Description Picture Specifications
Length: 2 meters
Wire Gauge: 24 AWG
Quantity: 50 each
Insulation Rating: 105
Voltage: 300 V
Length: 2 meters
Wire Gauge: 24 AWG
Outside Diameter: 0.1 inches
Quantity: 25 each
Insulation Rating: 250
Voltage: 600 V
Length: 10 cm
Wire Gauge: 24 AWG
Quantity: 10 each
Insulation Rating: 105
Voltage: 300 V
Wire Gauge Range: 20-26 AWG
Quantity: 250 each
Plating: Gold Plated Contact
Maximum Current: 2A at 70
o
C max
o
C max
o
C max
o
C
Chapter 1