Status:operation[:Event]; Status:preset - Agilent Technologies E1476A User Manual

STATus:OPERation[:EVENt]?

Comments
Example

STATus:PRESet

90 Switchbox Command Reference
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
STATus:OPERation[:EVENt]?
Group) that are set. The Event Register indicates when there has been a
time-related instrument event.
Setting Bit 8 of the Operation Status Register:
scanning cycle completes. Bit 8 returns to 0 (zero) after sending the
STATus:OPERation[:EVENt]? command.
Returned Data after sending the
returns "+256" if bit 8 of the Operation Status Register is set to 1. The command
returns "+0" if bit 8 of the Operation Status Register is set to 0.
Reading the Event Register with
Event Register Cleared:
STATus:OPERation:EVENt? clears the register.
Aborting a scan will leave bit 8 set to 0.
Aborting a Scan:
[ROUTe:]SCAN
Related Commands:
Reading the Operation Status Register After a Scanning Cycle
67$7 23(5"
UHDG WKH UHJLVWHU YDOXH
affects only the Enable Register by setting all Enable Register
STATus:PRESet
bits to 0. It does not affect either the "status byte" or the "standard event status".
PRESet does not clear any of the Event Registers.
returns the bits in the Event Register (Operation Status
Bit 8 (scan complete) is set to 1 after a
STATus:OPERation[:EVENt]?
Return the bit values of the Operation
Status Register
+256 shows bit 8 is set to 1.
+0 shows bit 8 is set to 0.
The command
:
Chapter 4