Power On/Off The Device - XAC xCL AT-170 Series Installation Manual

RONT AREA
REAR AREA
RIGHT SIDE
■
AT-170 Power spec:
Input: 5V DC, 2A
■
Power Adapter spec:
Input: 100 ~240 Vac
Output: 5V DC, 2A
Caution: Use only the AC adapter approved and provided by XAC Automation
Corporation for use with this device. Use of any other AC adapter may cause a risk of
fire or explosion.
■
Operating Temperature:
o
0 C to 40

3. POWER ON/OFF THE DEVICE

Power ON – Press and hold the Power key for 3 seconds until the screen is activated.
(Figure 2)
Power OFF -- Press and hold the Power key for 3 seconds to shut down the device.
1 7" Touch Display
Printer Paper Cover & Contactless Card Tapping Area
2
3 Camera for barcode scanning (Optional)
4 Smart Card Reader (SCR) slot
5 Audio Jack
6 Battery Compartment
7 Charging Contact
8 Magnetic Strip Reader (MSR) slot
9 Power Button (Press > 3 seconds to power on/off)
10 USB OTG port (type C)
o
C
Figure 2