Before Starting; Power O N /Off The Device - XAC XCE-25-C Installation Manual

1. B S
EFORE TARTING
There is a micro USB port (Figure 1) covered under the protection cover (Figure 2); this port is
used for battery charging, debugging, firmware update and key injection.
NOTE: The battery of xCE-25-C is built-in and rechargeable.
Operating Temperature: 0
Battery Pack: 3.7V, 1050mAh
Input: 5V, 500mA
2. P O /O
OWER N
To power on the device, press and hold the Power key for five seconds until the green LED
light flashes and the screen shows words. Once it is powered on, the LED will blink every five
seconds to indicate it is active.
To power off the device, press and hold the Power key for five seconds until the screen
become blank.
NOTE: xCE-25-C will power off itself automatically if unused for 5 minutes.
Figure 1
o
C to 40
D
FF THE EVICE
o
C
Figure 3
Figure 2