Cleaning: Cleanblast - Portable - JDS Uniphase CleanBlast FCL-P1005 User Manual

CleanBlast – PortaBle
CLEANBLAST OvERvIEW
The patented JDSU CleanBlast fiber end face cleaning systems provide a fast, effective, and cost-efficient solution
for removing dirt and debris from connectors in most common applications. CleanBlast is a non-contact system
that uses a highly filtered stream of pressurized gas with a vacuum circuit to create a high flow rate jet across the
surface of the fiber. A cleaning solvent is injected into the airflow, and the contamination from the end face along
with the solvent are then removed through the retrieval circuit. The precise, highly efficient non-contact air-
solvent-air stream blasts and removes loose debris with nearly 100-percent effectiveness.
Cleaning Tip run Button
solvent refill
AC Power Cord
handheld handset w/
5-ft Umbilical
CleanBlast – PortaBle
handset
Power switch
solvent refill Compartment
Prime Button
Air Filter Compartment
reset Button (press after replacing air filters)
Probe Input (disconnect probe and store after use)
system status LED's
Pelican™ Transport Case
6.4-in TFT LCD
Pouch for Probe
storage
Probe microscope
system status LED
Indicators
4-pin Probe Input
9