Inspect - JDS Uniphase CleanBlast FCL-P1005 User Manual

InsPeCt: BULKHEAD
SET-uP
1.
Connect and thread the 4-pin probe to the
probe input.
2.
Turn the system ON.
TIP INSTALLATION
3.
Install the correct bulkhead tip
to the probe microscope.
Note: Standard tips require barrel assembly
(see page 8 for tip installation guide and
Appendix A: Inspection Tips Reference Guide on
page 26).
INSPECT BuLKhEAD
4.
Insert the probe into the bulkhead to

inspect.

5.
Turn the focus control on the probe to focus
the fiber image on the display.
6.
Determine whether clean or dirty.
 If clean, do not touch it and CONNECT.
 If dirty, and if cleaning is required,
CLEAN.
12
1
Inspection Tip Barrel Assembly
4
Focus Control
User ManUal
INSPECT
2
3
6
5