Table of Contents
Advertisement
2.3 Requirements to staff
Qualifications
The different tasks described in this manual represent
different requirements to the qualification of the persons
entrusted with these tasks..
WARNING!
Danger in case of insufficient qualification
of the staff!
Insufficiently qualified persons cannot estimate the
risks while using the lift table and expose them-
selves and others to the danger of severe or lethal
injuries.
- Have all works only performed by qualified per-
sons.
- Keep insufficiently qualified persons out of the
working area.
Only persons reliable working procedures can be ex-
pected from, are allowed to perform all works. Persons
the responsiveness of which is affected by e. g. drugs,
alcohol or medication, are not allowed to work with the
machine.
The qualifications of the personnel for the different tasks
are mentioned below:
Operator:
The operator is instructed by the operating company
about the assigned tasks and possible risks in case of
improper behaviour. Any tasks which need to be per-
formed beyond the operation in the standard mode
must only be performed by the operator if it is indicated
in these instructions and if the operating company ex-
pressively commissioned the operator.
Qualified personnel
Due to their professional training, knowledge and expe-
rience as well as their knowledge of relevant regulations
the specialist staff is able to perform the assigned tasks
and to recognise and avoid any possible dangers them-
selves.
Manufacturer
Certain works may only be performed by specialist per-
sonnel of the manufacturer. Other personnel is not au-
thorized to perform these works. Please contact our cus-
tomer service for the execution of all arising work.
HT-Series | Version 1.01
2.4 Personal protective equipment
The personal protective equipment serves to protect
persons against impairments of safety and health while
working. The staff member has to wear personal protec-
tive equipment while performing different tasks on and
with the machine which are indicated in the individual
paragraphs of these instructions.
The personal protective equipment is explained in the
following paragraph:
Safety boots
The safety boots protect the feet against crushes,
falling parts and slipping over on slippery under-
ground.
Protective clothes
Protective clothes are made of a tightly fitted fabric
without the protruding parts of low tear strength.
2.5 Safety instructions
- The lift table may only be operated at sufficiently il-
luminated workstations.
- The lift table is intended for lifting, lowering and
moving loads.
- The lift table may only be used for lifting loads on
horizontal floors.
- The lift table may only be moved when the load is
lowered.
- When lifting and lowering, the lift table must be fre-
ely positioned in the room, i.e. the positioning of
the lift table must not cause any shearing or crus-
hing edges.
- The max. load with load centre in the middle of the
lift table must not be exceeded (If the lift table is
loaded outside the load centre, the load is re-
duced to up to 33% of the maximum load).
- The maximum lifting load with load centre in the
middle of the lift table must not be exceeded.
- The lift table is not intended for moving or trans-
porting persons.
- The lift table must not be operated in potentially
explosive work areas.
- The lift table may only be used for its intended pur-
pose!
Safety
5
Advertisement
Table of Contents
