Lifting And Lowering The Load - unicraft HT 300 S Operating Instructions Manual

Unevenly distributed longitudinal direction:
The load is distributed over half of the platform (longitu-
dinal direction). 33% of the nominal load is permitted.
Fig. 9: Unevenly distributed longitudinal direction

9.5 Lifting and lowering the load

Lifting
Before the lift table platform is raised, the lift table must
first be fixed in place by the rollers.
By repeatedly pressing the lever (Fig. 10), the platform
moves upwards. Lock the brakes before lifting and lo-
wering loads.
Fig. 10: Lifting the lift table: HT 300 (top), HT 300 L (bottom)
HT-Series | Version 1.01
Fig. 10: Lifting the lift table: HT 600
Make sure that you do not place any body parts (hands,
legs, etc.) under the table when the load is lifted. There
is a high risk of injury!
Lowering
The same requirements that applied in the previous
chapter apply here.
By lifting the lever (Fig. 11) the platform moves down-
wards (HT 300 S, M, M PSR, HT 600).
Fig. 11: Lowering the lift table: HT 300 S, M, M PSR (top),
HT 600 (bottom)
Operation
15