Programme Cancellation And Fault Indicator Light - Miele WTD 160 Operating Instructions Manual

Problem solving guide

Programme cancellation and fault indicator light

Problem
The fault indicator
light  lights up.  and
 alternate on the time
display and the buzzer
sounds.
The fault indicator
light  lights up.  and
 alternate on the time
display and the buzzer
sounds.
The fault indicator
light  lights up.  and
 alternate on the time
display and the buzzer
sounds.
 and  alternate on
the time display and the
buzzer sounds.
58
Cause and remedy
The water inlet is blocked or restricted.
 Check whether the stopcock has been properly
opened.
 Check whether the water inlet hose is kinked.
 Check whether there is sufficient water pressure.
The filter in the water inlet is blocked.
 Clean the filter.
The drain is blocked or restricted.
The drain hose has been fixed too high.
 Clean the drain filter and the drain pump.
 Check whether the maximum delivery head of 1 m
has been exceeded.
The water protection system has reacted.
 Close the stopcock.
 Call the Miele Customer Service Department.
There is a fault.
 Disconnect the washer-dryer from the electricity
supply. Switch off at the wall and withdraw the
plug from the socket, or disconnect the fuse.
 Wait at least 2 minutes before reconnecting the
washer-dryer to the electricity supply.
 Switch the washer-dryer back on.
 Restart the programme.
 If the fault message appears again, contact the
Miele Customer Service Department.