Miele WTD 160 Installation Manual
Hide thumbs
Also See for WTD 160:
- Operating instructions manual (100 pages) ,
- Operating instructions manual (100 pages)
Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Miele WTD 160
Summary of Contents for Miele WTD 160
- Page 1 *INSTALLATION* 11694001-01 Installation Front view a Water inlet hose e Detergent dispenser drawer b Electrical connection f Door c Flexible drain hose (with detachable g Access to drain filter, drain pump and swivel elbow) emergency release d Control panel h 4 height-adjustable feet...
-
Page 2: Rear View
*INSTALLATION* 11694001-01 Installation Rear view a Protruding lid for holding when d Safety caps for transit bars moving the machine e Transport clips for water inlet hoses b Drain hose and drain hoses c Water inlet hose f Electrical connection... -
Page 3: Installation Surface
*INSTALLATION* 11694001-01 Installation Installation surface Carrying the washer-dryer to its installation site A concrete floor is the most suitable installation surface. It is far less prone Danger of injury due to to vibration during the spin cycle than unsecured lid. wooden floorboards or a carpeted Make sure the fixings at the back of surface. - Page 4 *INSTALLATION* 11694001-01 Installation Then pull the transit bar out. Then pull the transit bar out. Covering the holes Removing the right transit bar Risk of injury from sharp edges! There is a risk of injury from reaching into holes that are not covered.
- Page 5 *INSTALLATION* 11694001-01 Installation Refitting the transit bars Installing under a continuous worktop Risk of damage from incorrect transport. Building under kits* must only be installed/dismantled by a specialist. The washer-dryer may become damaged if moved without the transit - A special building under kit* is bars in place.
-
Page 6: Levelling The Washer-Dryer
*INSTALLATION* 11694001-01 Installation Levelling the washer-dryer The washer-dryer must stand perfectly level on all four feet to ensure safe and proper operation. Incorrect installation may increase electricity and water consumption and may cause the machine to move about. The appliance must not be installed behind a lockable door, a sliding door or a door with a hinge on the opposite side to that of the... -
Page 7: The Miele Water Protection System
*INSTALLATION* 11694001-01 Installation Electronic unit and machine housing The Miele water protection system - Sump The water protection system protects all Any leaking water is collected in a parts of the washer-dryer from water sump in the base of the machine. A damage. -
Page 8: Water Intake
*INSTALLATION* 11694001-01 Installation Maintenance Water intake Only use a genuine Miele hose that has Health risk and risk of damage been pressure tested to withstand at due to contaminated incoming water. least 7,000 kPa should you ever need a The quality of the water used must replacement. - Page 9 (up to a max. of 1.8 m) a replacement drain pump will need to be fitted. a Adapter Please contact Miele for advice. In this case the hose can be extended to a b Washbasin nut maximum of 2.5 m. The necessary c Hose clip parts can be purchased from Miele.
-
Page 10: Electrical Connection
Connection should be made via a suitable switched socket. If the connection cable is damaged, it must only be replaced with a specific connection cable of the same type (available from Miele) in order to avoid a hazard. For safety reasons, such...