Programme Cancellation And Fault Message - Miele PDW 909 SOM Quick Start Manual

Programme cancellation and fault message

Problem
 F - Water drainage fault. If
restart fails, call Service.
 F - Water intake fault. If re-
start fails, call Service.
 Disinfection temperature
not reached
 Fault F. If restart fails, call
Service
Cause and remedy
The drain is blocked or restricted. The drain hose has been
fixed too high.
Clean the drain filter and the drain pump.

The maximum delivery head is 1 m.

The water inlet is blocked or restricted.
Check whether the stopcock has been properly opened.

Check whether the water inlet hose is kinked.

The water pressure is too low.
Switch on the Low water pressure setting (see "Low wa-

ter pressure" under "Supervisor level").
The water inlet filters are blocked.
Clean the filters (see "Cleaning the water inlet filters" un-

der "Cleaning and care").
The required temperature was not reached during the dis-
infection programme.
The washing machine has not carried out the disinfection

cycle correctly.
Start the programme again.

There is a fault.
Disconnect the washer-dryer stack from the electricity

supply.
Wait at least 2 minutes before reconnecting the washer-

dryer stack to the electricity supply.
Switch the washer-dryer stack on again.

Start the programme again. If the fault message appears

again, contact the Customer Service Department.
en - Problem solving guide
105