Table of Contents
Advertisement
Free motion darning, embroidery and
monogramming
Preparation for embroidering
and monogramming
* Embroider hoop is not included with
the machine.
- Install the darning plate, see page 35.
- Remove the presser foot and the
presser foot holder.
- Draw the desired lettering or design on
the right side of the fabric.
- Stretch the fabric between the
embroidery hoop as firmly as possible.
- Place the fabric under the needle.
Make sure the presser foot bar is down
to its lowest position.
- Turn the balance wheel towards you to
bring up the lower thread through the
fabric. Sew a few securing stitches at
the starting point.
- Hold the hoop with thumb and
forefinger of both hands while pressing
the material with the middle and third
finger and supporting the outside of
the hoop with your small finger.
Caution:
Keep fingers away from moving parts,
especially needles.
39
Advertisement
Table of Contents
