5
Remove the Rotary Selector.
Remove the Reflector.
Note on assembling:
∗12: Back light cable of TFT LCD must pass
through the gap between the ribs of Control
Panel (DNK6718) so as not to be pinched by
the LCDB ASSY.
∗12
rib
Control Panel
[2-3-10] TFT LCD,
Touch Panel
Remove the LCDB ASSY.
(Refer to the "[2-3-9] LCDB ASSY" .)
-----------------------------------------------------------------
Remove the four screws (BPZ26P080FTC)
and then remove the Stay (DNH3321).
Remove the TFT LCD and Touch Panel by
pushing from the top side.
Note: Don't touch the display surface of the TFT
LCD and Touch Panel barehanded.
Note on assembling:
When assembling, clear the dust by air blast.
[2-3-11] PARA ASSY
Remove the DPTH ASSY.
(Refer to the "[2-3-8] DPTH ASSY". )
-----------------------------------------------------------------
Remove the six Knobs (DAA1358).
Note: In case the dessert spoon is used, take
care not to damage the Panel (DAH3165).
5
6
LCDB ASSY (side-A)
back light cable
Front
Front
Front
Front
DJS-1000
6
7
Rotary Selector
Reflector
Stay
TFT LCD, Touch Panel
x 6
Knob
7
8
A
B
C
D
E
Panel
F
41
8