1
[2-2-4] SW POWER SUPPLY
A
Remove the MAIN ASSY and AUDB ASSY.
(Refer to the "[2-2-2] MAIN ASSY" and "[2-2-3] AUDB ASSY" .)
-----------------------------------------------------------------
Remove the ten screws (BPZ30P080FNI) and then remove
the Shield Case (DNH3326).
Disconnect the two connectors.
Note ∗7: CN1 and CN2 have lock mechanisms.
B
Remove the two screws. (BPZ30P080FNI)
Remove the four screws (BBZ30P060FTB) and then remove
the SW POWER SUPPLY.
Note on assembling:
Attach first two screws in the order as shown by blue numbers.
Remaining two screws can be attached in any order.
[2-2-5] AC Inlet
Remove the SW POWER SUPPY.
C
(Refer to the "[2-2-4] SW POWER SUPPLY" .)
-----------------------------------------------------------------
Release the AC inlet cable from the Holder (VEC1355).
Remove the two screws (BPZ30P080FNI) and then remove the
SSK3 ASSY.
Notes on assembling
∗8: AC inlet cable must pass through the rear side of the Chassis's rib.
∗9: Style the AC inlet cable so as not to touch the Stay (DNH3323)
and screws.
Remove the screw. (BBZ30P060FTB)
D
Note: After the product No.1711 only.
Remove the 11 screws. (BPZ30P080FNI)
Remove the Stay (DNH3323) while pulling the AC inlet cable out of
the hole.
Note: LSYXJ: Lot 1 to 1010 and UXJCB: Lot 1 to 640 have the Earth
Lead Wire (DDX1286).
For details, refer to the
"[3-2-2] Correspondence
for Earthing Improvement"
E
Remove the two
Acetate Cloth Tapes.
Unhook from the Holder.
Earth Lead Wire
Stay
F
Front
36
1
2
Front
Front
Front
Earth Lead Wire
Remove the Stay
while pulling the
Earth Lead Wire
Front
out of the hole.
DJS-1000
2
3
:
x 10
Shield Case
1
∗7
CN2
SW POWER SUPPLY
:
x 11
Stay
∗9
∗8
rib
AC Inlet
Holder
3
4
2
∗7
CN1
AC Inlet
SSK3 ASSY
∗9
4