1
A
Remove the Control Panel Section and
arrange it as shown in the photo.
Note: Pay attention for the three cables
connected.
Release the Shielded Conn-cable
B
(DDA1081) from the Cord Clamper (Steel).
Note on assembling
∗1: Insert the tip of the Cord Clamper (Steel)
into the latch of the Chassis's rib.
Disconnect the three connectors.
Note
∗2: CN1 and CN2 have lock mechanisms.
C
Shielded Conn-cable
CN7400
HPJA ASSY
D
[2-1-2] Shield Case (DNH3322)
Remove the Control Panel Section.
(Refer to the "[2-1-1] Control Panel Section")
-----------------------------------------------------------------
E
Disconnect the connector and then remove
the INVR ASSY (with the Stay (DNH3319) ).
F
32
1
2
Cord Clamper (Steel)
∗1
latch of Chassis's rib
INVR ASSY
Front
DJS-1000
2
3
Control Panel Section
CN7301
3
4
Chassis Section
FFC (DDD1820)
∗2
CN2
∗2
CN1
MAIN ASSY
4