Table of Contents
Advertisement
USB Gateway
USB Gateway Installation
DO NOT CONNECT THE USB GATEWAY TO
YOUR COMPUTER UNTIL INSTRUCTED TO DO
SO BY THE INSTALLATION WIZARD
The following instructions will guide you to through the process of installing the Personal
USB Gateway.
The installation procedure is to:
• Install Skype™ (step 1 below)
• Start the USB Gateway installation (step 2 below)
• Plug in the USB Gateway WHEN INSTRUCTED TO DO SO (step 2 below)
• Verify the installation is OK (step 3 below)
• Connect a telephone handset to the USB Gateway (step 4 below)
• Connect the USB Gateway to the wall jack (step 5 below). Note that this is
optional and only required for the forwarding and conferencing features.
• Use your USB Gateway to make and receive Skype™ calls
• Use the USB Gateway as an answering machine
The detailed instructions follow:
STEP 1:
If Skype™ is not already installed on your computer, visit
http://www.skype.com
Skype™ is working before installing the USB Gateway.
and follow the instructions there to install Skype™. Verify that
Page 6 of 48
Advertisement
Table of Contents
Need help?
Do you have a question about the Gateway AU-600 and is the answer not in the manual?