Answering Machine (Pstn & Voip) Support - ATCOM Gateway AU-600 User Manual

USB Gateway
Answering Machine (PSTN & VoIP) Support
1 USB VoIP Gateway has an integrated answering machine (implemented in software
on the PC).
2 USB VoIP Gateway can be configured to answer incoming VoIP call using its
answering machine after a configurable number of rings.
3 USB VoIP Gateway can be configured to answer incoming PSTN call using its
answering machine after a configurable number of rings.
4 The USB VoIP Gateway comes with a default greeting message.
5 The user may record his own greeting message (either locally using the handset or
remotely through administrative remote mode).
6 When the use has voicemails (either on the local answering machine or on the VoIP
network voicemail) USB VoIP Gateway would play a special dial tone under VoIP
mode to indicate the waiting messages.
7 The VoIP Dial tone when there are no message is a continuous tone
The VoIP dial tone when there are new message/s is a continuous tone with 'beep-
beep' abruptions every 3 seconds.
8 The user may access the local answering machine system to configure it or to listen
to his voice message through an Interactive Voice Response System. Through the
response system the user may also access the soft phone (VoIP network) voice mail
– than he may continue per the description in following section.
More details about the IVR (Interactive Voice Response) system can be found in
appendix A below.
Below is about how to set answering machine to work:
Enable Answering for Skype calls
Enable Answering for PSTN calls
Page 31 of 48