Table of Contents
Advertisement
Nokia FastMile 4G Receiver Installation Guide
Procedure 9
Issue: 01
To mount and connect the Nokia FastMile 4G Receiver
1
Confirm that the location identified in chapter
home, and that Ethernet cabling can be safely and securely run from the mounting location
though the wall, and inside the home to the residential gateway or PoE injector, or to the
prospective residential gateway or PoE injector location. The PoE injector must be a
Nokia-approved PoE injector. Class I and Class II PoE injectors are available from Nokia for
use with the FastMile 4G Receiver:
•
Class I: can comply with EN 60950-1 if grounding is provided on the wall socket; should
be put as close as possible to the place where the Ethernet cable enters the home; see
section
6.2
for more information
•
Class II: can comply with EN 60950-1 if no grounding is provided on the wall socket; can
also be used if grounding is provided on the wall socket; see section
information
2
Make sure that you have the following from the shipping package as appropriate:
•
Nokia FastMile 4G Receiver
•
bracket kit consisting of:
•
mounting plate
•
receiver bracket: note that the receiver bracket is shipped attached to the mounting plate
with three fasteners
•
two fasteners for attaching the mounting plate to the Nokia FastMile 4G Receiver
•
pole adapter
3
Separate the mounting plate from the receiver bracket and save the three fasteners for
securing the mounting plate to the receiver bracket later on in this procedure.
4
Use the two supplied screws to attach the mounting plate to the back of the Nokia FastMile
4G Receiver as shown in Figure 48. Be sure to orient the mounting plate as shown in the
figure.
3TG-00387-ABBA-TCZZA
Mounting and connecting the Nokia FastMile 4G
10
is suitable for considerations within the
Receiver
6.2
for more
89
Hide quick links:
Advertisement
Table of Contents
