Figure 54 Location Of The Waterproof Plug (Compact Multi-Band Models Only) - Nokia FastMile 4G Installation Manual

Mounting and connecting the Nokia FastMile 4G
Receiver
94
11 Rotate the Nokia FastMile 4G Receiver +/-35 degrees horizontally so that it faces the
direction of the LTE base station that was determined in chapter 10, and tighten the fasteners
to securely hold the Nokia FastMile 4G Receiver in place.
Note that if needed, you can rotate the Nokia FastMile 4G Receiver horizontally later on by
loosening the fasteners, rotating the Nokia FastMile 4G Receiver, and tightening the
fasteners.
12 If you are installing a Compact multi-band model of the Nokia FastMile 4G Receiver, you will
need to provide and attach a cat5e shielded Ethernet cable that has standard pinouts and is
a maximum of 80 m (262 ft) in length to the Ethernet port of the Nokia FastMile 4G Receiver
as described below (you will need to provide a male RJ 45 connector to connect the Ethernet
cable to Nokia FastMile 4G Receiver):
i Remove the waterproof plug and gland from the Ethernet port of the Nokia FastMile 4G
Receiver. Figure
Figure 54 Location of the waterproof plug (Compact multi-band models
only)
ii Slide the end of the Ethernet cable through the waterproof plug and gland that were
removed from the Ethernet port, and attach the male RJ 45 connector to the end of the
Ethernet cable.
3TG-00387-ABBA-TCZZA
Nokia FastMile 4G Receiver Installation Guide
54 shows the location of the waterproof plug.
Waterproof plug for
connecting Ethernet cable
28887
Issue: 01