Safety Warnings - emmeti SINTESI User Manual

Electronic touch screen chronothermostats with wall-mounting suitable for the
temperature control in household. Two versions are available:
SINTESI chronothermostats, battery powered, with backlit monocolor display
(blue) and input for external contact configurable for the connection of an external
temperature probe or of an auxiliary contact with whom to switch on/to switch off
the chronothermostat remotely (by telephone).
SINTESI chronothermostats, mains powered, with backlit monocolor display,
which changes tone according to the gap between the environment temperature
and the setpoint.
These devices perform actions of 1B type and are intended for operating in
environments Pollution degree 2 and Overvoltage Category III (EN 60730-1).
During product installation and operation it is necessary to observe the
following instructions:
1) The device must be installed by a qualified person, in strict compliance with
the connection diagrams.
2) Do not power or connect the device if any part of it is damaged.
3) After installation, inaccessibility to the connection terminals without
appropriate tools must be guaranteed.
4) The device must be installed and activated in compliance with current electric
system standards.
5) Before accessing the connection terminals, verify that the leads are not live.
6) In the electrical system of the building where the device must be installed,
a switch and a protection device from the overcurrents must be present (for
SINTESI 230 models only).
Code Description
02018154 SINTESI battery powered touchscreen chronothermostat
02018152 SINTESI mains powered touchscreen chronothermostat

SAFETY WARNINGS

- 5 -
SINTESI Chronothermostat User Manual