Chronothermostat Reset; Battery Replacement - emmeti SINTESI User Manual

If you want to erase all performed settings and to recharge the default values, proceed
as follows:
1. to switch off and to switch on the power of the chronothermostat (230 V versions)
or to disconnect the time thermostat from the wall-mounted base and reconnect it
(battery versions).
2. during the flashing of the keys press the key
.
Default values are indicated on page 33 of this manual.
The models SINTESI Bianco and SINTESI Nero signal the status of depleted batteries
switching on the symbol
In this status the regulation is always guaranteed, but it's advisable to replace the
batteries as soon as possible! (*)
If the charge level of batteries further decreases, the chronothermostat enters into less
consumption mode, it switches off the display and it doesn't perform any regulation.
(*) Remove the depleted batteries and replace them with the new ones in a maximum
time of one minute (charge reserve) to avoid to lose the settings of date and time
(the performed programmings on the contrary remain memorized even if this limit is
surpassed).
Attention: after batteries replacement, the display will switch on within 15
seconds at max.
Dispose of the used batteries observing
the laws in force in relation to the
disposal of hazardous waste.

CHRONOTHERMOSTAT RESET

BATTERY REPLACEMENT

(field (10)) and making the display to flash.
- 31 -
SINTESI Chronothermostat User Manual
until the display shows the writing