Sip Contemporary Cordless 1-Line Accessory Handset & Charging Stand - Ctm-S2415Hc - VTech SIP Contemporary Series Master User Manual

SIP Contemporary Cordless 1-line
Accessory Handset & Charging stand -
CTM-S2415HC
Charger base installation
The telephone comes ready for desktop use.
1. Install the charger base as shown below.
• Make sure the power adapter is securely
plugged into an outlet not controlled by a
wall switch.
2. Bent a small paperclip and gently insert it
to the Handset battery ON pinhole to turn on the
handset.
• Without turning on the battery, the handset
cannot be charged or operate.
• The battery is fully charged after 16 hours of
continuous charging. For best performance,
keep the cordless handset in the charging
base when not in use.
/SPEAKER on the handset. Listen for
3. Press
a dial tone, and then press
to hang up.
CAUTIONS
Use only the supplied power adapter. The
supplied power adapter is not designed for
use in any other IT devices. Misuse it on your
other IT devices shall be prohibited. To order a
replacement, call 1-888-907-2007.
Handset registration
Place the cordless handset on the telephone base
cradle. Handset registration happens automatically
the first time a cordless handset is placed on the
telephone base.
When the registration process completes, the
MESSAGE WAITING LED flashes once and you
hear 3 rising beeps as confirmation.
Each telephone base accommodates up to 4
cordless handsets. When you already have 4
registered handsets, you can replace one of them
by a new handset if any one of the 4 registered
handsets is disconnected from the base. For
example, it is out of range, or its battery is
removed or depleted. The previous registered
handset is then deregistered from the telephone
base.
Handset deregistration
When a registered cordless handset is idle, press
*331734#, then press HOLD and *883247#. You
hear a confirmation tone when the deregistration
process completes.
Register a handset to another telephone
base
Any contemporary cordless 1-line handset can
register to any contemporary cordless 1-line
telephone base. Any contemporary cordless 2-line
handset can register to any contemporary cordless
2-line telephone base.
When a registered cordless handset is idle, place it
on another telephone base. This cordless handset
automatically registers to the new telephone base.
/SPEAKER again
Handset battery charging
The battery must be fully charged before using the
cordless handset for the first time. The CHARGE
LED turns on when the cordless handset is charging
on the telephone base, charging base or charging
stand. The battery is fully charged after 16 hours
of continuous charging. For best performance,
keep the cordless handset in the telephone base,
charging base or charging stand when not in use.
EN - 13