Table of Contents
Advertisement
DS3 Interface
The DS3 network interface is a full-duplex circuit provided by two
BNC coaxial cable connections. The receive data from the network
is connected to the
the T3SU 300 is connected to the
FRONT PANEL
The T3SU 300 faceplate is shown in Figure 2-3. Descriptions of each
part of the front panel follow.
Control Port
The T3SU 300 has an 8-pin modular jack labeled
control port provides connection to a VT-100 EIA-232 compatible
interface.
Establishing Terminal Connection
To control the T3SU 300 using a VT-100 terminal, follow this
procedure:
1.
2.
3.
4.
61200217L1-1
RX IN
Configure the VT-100 terminal for 9600 baud, 8-bit characters,
no parity, and one stop bit (9600, 8N1).
Using the ADTRAN-provided terminal interface cable adapter,
connect the DTE port of a terminal to the 8-pin modular jack
labeled
on the front panel of the T3SU 300.
CONTROL
Initialize the terminal session.
Press Enter repeatedly until the password prompt appears.
T3SU 300 User Manual
Chapter 2. Installation and Operation
connector, while the transmit data from
connector.
TX OUT
Figure 2-3. T3SU 300 Front Panel
. The
CONTROL
2-7
Advertisement
Table of Contents
