Table of Contents
Advertisement
Diagnostics
Chapter 6
The D
tests from the T3SU 300. Figure 6-1 shows the main D
menu. Perform tests for the entire DS3 or for an individual DTE
port. If a Quad DSX-1 card is installed, activate loopback tests for
an entire card (all four DSX-1s) or for an individual DSX-1 port.
To choose a DTE port from the left column of the menu, select the
port's corresponding number and press Enter. The individual port
menus provide loopback and BERT selections. BERT configuration
options and results are given in the right column of the main
D
IAGNOSTICS
Diagnostic selections are described in the following portions of this
chapter:
DS3 Options: page 6-2 through page 6-4
HSSI and V.35 Port Options: page 6-4 through page 6-7
Quad DSX-1 Interface Card Options: page 6-8 through page 6-13
BERT Configuration Options: page 6-14 through page 6-15
You can only perform a BERT test on one DTE port at a time. If a BERT
test is already in progress and a second BERT test is selected for another
port, the first test is discontinued.
Loopback tests may be performed simultaneously on all four DTE ports.
61200217L1-1
menu allows you to initiate loopback and BERT
IAGNOSTICS
menu.
T3SU 300 User Manual
IAGNOSTICS
6-1
Advertisement
Table of Contents
