Advertisement
8.
Release the rocker switch to proceed to the next
step in the sequence
9.
Make the pipe connection; refer to Adding Drill
Pipes in the Operator's Manual.
10.
Hold the lower button on the joystick
36) to release the pipe
the button.
(Figure
35).
Figure 35
(Figure
(Figure
37) and release
Figure 36
Figure 37
11.
Hold the lower section of the rocker switch
(Figure
39) until the loader arms rotate back and
the cam assembly returns to the home position
(row 4)
(Figure
g231720
g210527
g232385
12.
Release the rocker switch to start the push-pipe
process again. The cam assembly goes to
the row picked in step
SmartTouch Mode (page
8
40).
Figure 38
Figure 39
Figure 40
2
of
Pulling Pipe in
2).
g231721
g210462
g232386
Advertisement
