Advertisement
1. Pull pipe
2. Push pipe
3. Rotary torque
SmartTouch™ Home
Screen
SmartTouch mode allows the operator to load and
unload pipes from the rod box with less joystick
operation to reduce operator fatigue.
Use the
Carriage Settings Screen (page 10)
SmartTouch mode on and off.
Note:
The Push/Pull Icons have a green background
when SmartTouch mode is on and a ribbon appears
at the bottom of the screen showing a sequence of
the steps.
Important:
Never switch between Push/Pull
modes during the chosen operation. Use neutral
(manual) mode to switch between Push/Pull; refer
to
Carriage Settings Screen (page 10)
SmartTouch mode off.
The SmartTouch screens appears along the bottom of
the home screen as shown below.
Figure 3
4. Thrust force
5. Drill speed (rpm)
to turn
to turn
Figure 4
Pulling Pipe in SmartTouch Mode
Start the SmartTouch mode with the cam assembly in
the home position (row 4 of the pipe box).
Important:
Ensure that you hold the lower section
of the cam rocker switch, on the left joystick,
completely down until the action is complete in
each step
(Figure
g213150
Hold the upper section of the cam rocker switch,
on the left joystick, completely down until all
actions are complete to go to the previous step in
the sequence
1.
Push button 1 to select the pull pipe option
(Figure
7).
g231722
2
5).
Figure 5
(Figure
6).
Figure 6
g210060
g210061
Advertisement
