Advertisement
Mud or Air Hammer Selection
Screen
Push button 8 on the Settings screen to access this
screen. Use the up and down arrows to switch been
mud and air hammer.
This updates the display on the home screen
1).
Figure 54
I/O Screens
Joystick I/O Screen
Push button 1 on the I/O screen to rotate between the
Drill and Setup options. The icon turns green when
the associated function is actuated.
When the rocker switch on the left control panel is in
the Drill position, the upper left icon turns green and
the joystick voltages can be checked as well as verify
the 2-Speed, and Exit Side Lockout inputs.
When the rocker switch is in the Setup position, the
upper right icon is green. The setup position allows
you to move the machine and prepare for drilling.
Figure 55
•
The rotary voltage ranges from 0.0 to 8.5 V and
can be present for either make (upper icon) or
break (lower icon) as the selected rotary joystick is
moved.
•
The carriage indicates a voltage range from 0.0 to
10.0 V in the joystick selected direction for thrust
or pullback.
(Figure
•
The lower left icon indicates the carriage position
of wrench, load, or carriage back as the carriage
moves to the most rearward positions.
•
The lower center icon indicates if the 2-speed
selection of the carriage speed has been selected.
•
The lower right icon indicates the status of the Exit
Side Lockout (ESL). If the indicator is black, the
carriage and rotary actions are inhibited.
Engine I/O Screen
To access this screen push button 2 on the I/O screen.
g233213
This screen displays engine information.
1. Engine speed (rpm)
2. Engine-oil pressure
3. Battery voltage
4. Engine temperature
5. Hydraulic-fluid
temperature
Engine speed (rpm) icon: displays, in steps of 100,
the engine speed (rpm).
Engine-oil pressure icon: displays the engine-oil
pressure (bar or psi).
g224025
Battery voltage icon: displays the battery voltage.
12
Figure 56
6. Air-filter indicator
7. Hydraulic-fluid filter
8. Engine load
9. Engine droop
g213149
Advertisement
