Advertisement
Replacing the coil cord
Do not use a cord with a diameter greater than recommended. Increasing the diameter of
the fishing line leads to an overload of the engine and a reduction in the quality of mowing.
To replace the cord, follow these steps:
•
Press on the two coil latch latches located on the side and remove the lid.
•
Remove the bobbin and spring.
•
Clean the spool from the remnants of the used cord.
•
Cut 5-6 meters of the new cord, fold it in half and fix the inflexion point of the cord
in the spool in the same way as the used cord was fixed.
•
Wind the cord on the spool in two streams in one direction. If there is a separating
rib in the spool, wind each stream in its channel.
•
Fix the ends of the cord, leaving 15-20cm free, in special slots of the spool, which
will allow you to assemble the reel without unwinding the cord.
•
Insert the free ends of the cord into the holes of the coil cover install the spring,
spool in the coil body, fix the cover.
•
With a sharp movement pull the ends of the cord out of the reel by 1-2cm, so that
the cord comes out of the slots of the spool and the spool moves to the working
position.
When the cord is correctly wound and the coil is assembled while the free ends of the cord
are pulled out and the coil button is briefly pressed, the cord should be released 20-25mm.
After refilling the cord, if necessary, cut off the excess free cord so that the ends have the
same length of no more than 20cm.
Advertisement
