Advertisement
Trimmer coil use
The trimmer should move parallel to the ground. When mowing high and/or soft
vegetation, make sure that the mowed grass does not wind on the trimmer reel axle. This
complicates the rotation of the drive shaft and increases the load on the engine. Grass
spooled on the axle can lead to heating and melting of the coil, breakage of the driveshaft,
overheating of the engine and its failure.
During operation, it is recommended to keep the trimmer in front of you, tilting so that the
lower part of the coil does not touch the ground and the tip of the cord is at the desired
cutting height. The trimmer should be kept in such a way that cutting grass occurs in the
direction away from the operator.
When processing areas adjacent to fences, fences, stone walls and foundations, the
trimmer should be moved slowly, trying to cut the grass as close as possible to the barrier,
without touching it. Otherwise, the cord may be wrapped around the barrier and cut off with
the release of cord fragments in an arbitrary direction, which may result in injury.
When working around trees, the trimmer should be moved slowly and carefully, so that the
cord does not touch the tree trunks and does not damage them. Trees when mowing grass
go around from left to right.
Note:
High grass is recommended to mow in 2-3 passes, depending on the height of the
grass.
After work, clean the trimmer from the remnants of the mowed grass; especially taking care
to clean wound grass from the coil axle. When cleaning the axle in some cases it is required
to remove the head. Note that the axis has a left-hand thread and, when removing the coil,
it must be rotated clockwise, locking the axis, as indicated in the "Trimmer coil installation"
section of this manual above.
The trimmer is equipped with a semi-automatic coil. To release the cord from the trimmer
coil, without reducing the engine speed, hit the coil button (located in its lower part) lightly
on the ground. Under the action of centrifugal forces, the cord will be lengthened; the
excess parts will be trimmed with a blade located in the casing apron.
WARNING:
the coil too hard. Determine the minimum required force of impact
experimentally, gradually increasing it, starting with the smallest.
To avoid the destruction of the trimmer coil, do not strike
Advertisement
